Fix Your PC did not start Correctly | How To Solve Automatic Repair loop Error Windows 11 /10/8/7
If your PC is stuck in an Automatic Repair loop and is displaying the “Your PC did not start correctly” error message, there are several steps you can try to resolve the issue. Here are some solutions you can attempt:
- Restart your PC: Sometimes a simple restart can fix temporary issues. Press and hold the power button until your computer turns off, and then turn it back on after a few seconds.
- Disconnect peripherals: Unplug all external devices such as USB drives, printers, or any other devices connected to your PC. Sometimes, a faulty or incompatible peripheral can cause startup issues.
- Check hardware connections: Make sure that all internal hardware components such as RAM modules, hard drives, and cables are properly connected. Open your PC case (if applicable) and ensure that everything is securely in place.
- Run Startup Repair: Windows has a built-in tool called Startup Repair that can automatically diagnose and fix certain startup issues. To access it, follow these steps:
- Boot your PC and when the Windows logo appears, press and hold the power button until your computer shuts down. Repeat this process two more times.
- On the third restart, Windows should enter the Automatic Repair mode. Select “Advanced options” > “Troubleshoot” > “Advanced options” > “Startup Repair.” Follow the on-screen instructions to complete the repair process.
- Use System Restore: If you have previously created a system restore point, you can try restoring your PC to an earlier state when it was functioning correctly. Here’s how:
- Boot into the Advanced options menu following the steps mentioned in the previous solution.
- Select “System Restore” and choose a restore point from the list. Follow the instructions to initiate the restoration process.
- Check disk errors: Corrupted system files or hard drive errors can cause startup problems. To fix this, you can use the built-in Windows utility called Check Disk (CHKDSK):
- Access the Advanced options menu as described before.
- Select “Command Prompt” and type the command: chkdsk C: /f /r /x (replace C: with the drive letter where your Windows is installed).
- Press Enter and wait for the disk checking process to complete. This may take some time.
- Refresh or Reset your PC: If none of the above solutions work, you can try refreshing or resetting your PC. Be aware that this will remove your installed applications and potentially delete your personal files, so make sure to back up your important data before proceeding. To refresh or reset your PC, follow these steps:
- Access the Advanced options menu.
- Select “Troubleshoot” > “Reset this PC” or “Reset your PC.” Choose either the “Keep my files” or “Remove everything” option based on your preference and follow the on-screen instructions to complete the process.
If none of these solutions resolve the issue, it’s recommended to contact Microsoft support or seek assistance from a professional technician for further troubleshooting.